Which Underfloor Heating?

Our range has won several awards and heats up at a significantly faster rate than other less powerful systems. Its design is also super thin, ensuring that floor levels are only increased by a few millimetres. Our 200W underfloor heating mats are considerably easier to operate than traditional heating systems, and if you use our product in conjunction with one of our 4th generation thermostats they can provide a generous heat source for tile or stone floors.

• Designed to provide a source of heat in conservatories and rooms which lose heat very easily
• Significantly reduces the time it takes to heat up compared to less powerful systems.
• If used in combination with one of our intelligent thermostat timer, 200w systems are more energy efficient and cheaper to run than other products which run on a lower wattage.
• Our ultra-modern underfloor heating cables offer a high powered heating cable whilst adding as little height to the floor surface.

Ensure you select the right size heating mat First off, you will have to calculate the floor area which will need to be covered. An easy way to do this is to first of all work out the total floor area of the room and then subtract the particular areas on which there will be furniture placed, a toilet or shower, or where furniture without a gap of air underneath it might be placed. When this total has been reached you now have your free floor area (FFA). If a room is any size up to 8 square metres, our recommendation is that a combination of heating mats is chosen which cover up to 90% of you FFA, and for any room larger than that size we recommend that you try to cover at least 95% of the FFA.

Combinations of units Our heating mats are purposely designed so that they can be laid alongside other mats, making sure they fit perfectly every time. They are all wired together into a single thermostat to make it easier to control from one source. It is important to note that this is only possible if all of the mats are 200w/sqm Extra fast installation Our underfloor heating mats are very easy to install, and in comparison to a loose heating cable would take a third of the time to install. They can be cut to any size and rotated to fit any room perfectly, and it necessary, the cable can be removed from the mat and can be laid as a loose heating cable.

The attached adhesive tape easily affixes to a clean floor surface, and the durable fibreglass net above the cable stops the cables getting damaged or affected during the tiling process. Independently guaranteed All of our heating mats are approved by the British Electrotechnical Approvals Board (BEAB) and Semko, are fabricated in Denmark in our approved factory and supplied with a lifetime warranty. They are also certified by Semko as one of the lowest emitters of EMC radiation - a result of our twin conductor designed cables, all with a 100% aluminium earth shield.